Internova™ 1000 Help

PREPARING FOR USE

We have designed the Internova™1000 to be incredibly bright, long-lasting, and simple to use. Please follow the instructions below to get the most out of your lantern; and should you ever have any questions at all, please don’t hesitate to contact us at care@intevine.com.

Battery installation
1) Remove the rubberized base cap on the bottom by rotating it counter-clockwise and pulling it out.
2) Install 4 D size batteries, making sure that the positive and negative ends are inserted correctly as indicated on the lantern.
3) Replace the rubberized base cap by aligning the guide post to the corresponding slot on the battery compartment, sliding the post into the slot, and then twisting the base cap clockwise while pushing down to lock into place.

Lantern Operation
The Internova™ 1000 comes with one power button that is used to power the lantern on/off as well as cycle through all available modes.

Powering On
To turn on the Internova™ 1000, simply press and release the round button in the middle of the lantern.

Cycling Through All Modes
With four modes to choose from, the Internova™ 1000 is the only lantern of its kind to offer a dimmer mode.

Mode 1 - Pressing the power button once puts the lantern into the LOW mode.

Mode 2 - To access HIGH with DIMMER mode, from the LOW mode press and hold power button (if you fail to press and hold the power button from the LOW mode, the lantern will skip the HIGH with DIMMER mode and proceed directly to the RED mode). Continue to hold to reach peak brightness. You will see the bulb flash indicating the lantern has reached maximum brightness. If you continue to hold, the bulb will begin to decrease in brightness and continue to the bulb’s lowest brightness. When the bulb has reached the lowest brightness, it will flash again. At any point while dimming, you can let go of the power button to maintain your preferred brightness.

Mode 3 - From the HIGH with DIMMER mode, Press the power button once to access the RED mode (alternately, if you fail to press and hold the power button from the LOW mode, the lantern will skip the HIGH with DIMMER mode and proceed directly to the RED mode).

Mode 4 - From the RED mode, press the power button once to access the RED SOS mode.

Powering Off
To turn off the Internova™ 1000, cycle through modes 1-4, you can press the power once from mode 4 (RED SOS) to turn lantern off.

Warranty
Your Internova™ 1000 comes with a 5 year manufacturer’s warranty. To activate warranty, go to www.intervine.com/register, fill in your product information, and submit.  Additional warranty information can be found here.